$84.49
Brand: StrongTools
Features:
Details: 【Warm Tips】
Use a clean lubricated air supply that will give a measured air pressure at the tool of 6.2 bar (90psi) when the tool is running with the lever fully depressed. It is recommended to use an approved 10 mm (3/8 in) × 8 m (25 ft) maximum length airline. Connect the tool to the air supply as do not connect the tool to the airline system without an easily accessible air shut off valve. It is strongly recommended that an air filter, regulator and lubricator (FRL) be used as this will supply clean, lubricated air at the correct pressure to the tool. In any case appropriate air pressure regulators shall be used at all times while operating this tool where the supply pressure exceeds the marked maximum of the tool. Details of such equipment can be obtained for your tool distributor.
If such equipment is not used, the tool should be manually lubricated. To manually lubricate the tool, disconnect the airline and put 2 to 3 drops of suitable pneumatic motor lubricating oil into the hose end of the tool. Reconnect tool to the air supply and run tool slowly for a few seconds to allow air to circulate the oil. If the tool is used frequently, lubricate it on a daily basis or lubricate it if the tool starts to slow or lose power. It is recommended that the air pressure at the tool be 6.2 bar (90psi) while the tool is running so the maximum RPM is not exceeded. The tool can be run at lower pressures but should never be run higher than 6.2 bar (90psi). If run at lower pressure the performance of the tool is reduced.
【Specifications】
☛Body Material: Aluminum Alloy
☛Sanding Pad: 5 inch or 6 inch
☛Free Speed: 10000RPM
☛Pendulum Diameter: 1/4″
☛Working Pressure: 6.3bar
【Package Included】
◆1 x Air Sander
◆1 x Quick Connector
◆1 x Wrench
◆5 x 5in. Sandpaper
◆5 x 6in. Sandpaper
◆1 x TeflonTape
◆1 x User Manual
◆1 x Dust Pipe
◆1 x Dust Bag
UPC: 723508605989
Package Dimensions: 124x224x1542