PGFUN CNC 3D Touch Probe Upgraded XYZ Axis Anti-roll Edge Finder Waterproof 3 Coordinate Measuring Sensor Kit with 6mm Shank & Cable, Compatible with Mach3 and Grbl (Edge Finder-NO)

Brand: PGFUN

Features:

• The 3 coordinate XYZ axis touch probe can achieve fast centering, edge finding, center finding, flatness acquisition, shape measurement and other functions by connecting the control panel (mach3, grbl), which perfectly solves the problem of positioning the parts during the 2nd tightening.
• Main Specs: power: DC5-24V, NPN-NO wiring, repeatability accuracy: 0.01 mm/ 0.0004 in, feedrate: 50-200 mm/min, over travel protection distance: X- ±4mm/0.16 in, Y- ±4mm/ 0.16 in, Z- 2mm/ 0.08in,
• Material: fine frosted black oxidized aluminum alloy with a flat surface anti-roll design, protect the digitizing touch probe from dropping.
• Compatible with: Mach3 and GRBL control system.
• Package Include: 3D touch probe x 1, cable x 2 m/ 6.5 ft, allen wrench x 1, straight probe tip x 1, 1 in 2 out wire connector x 2 (to solve the insufficient problem of control board wiring ports).

Details: PGFUN 2022 The Latest V6 Pro Anti-roll 3D Touch Probe New Upgraded Waterproof Edge Finder

Specification:
Power: DC5-24V
3 NPN-NO Wiring: Red-VCC (DC5-24V power), Yellow: IO/ Signal Output, Black- GND(DCM)
Repeatability Accuracy: 0.01 mm/ 0.0004 in.
Feedrate: 50-200 mm/min.
Approach Direction: ±X, ±Y, +Z.
Over Travel Protection Distance: X- ± 4mm/0.16 in , Y- ±4mm/ 0.16 in, , Z- 2mm/ 0.08 in.
Lifetime: > 3 million triggers.
Material: fine frosted black oxidized aluminum alloy with a flat surface anti-roll design.
Fit for: Mach3 and GRBL
Package Include: 3D touch probe x 1, cable x 1, allen wrench x 1, straight probe tip x 1, 1 in 2 out wire connector x 2 (to solve the insufficient problem of control board wiring ports).

Software Recommendation for 3D Probe
If you are using a mach3 system, it is recommended to use the open source Probe Wizard or ProbeIt
If you are using the grbl system, it is recommended to use GRBLGRU.

FAQs:
Q1: Need to turn on the spindle speed?
A1: Definitely no, or it’ll cause data tolerance.

Q2: Why is the concentricity different when the probe is installed?
A2: Because the low-accuracy spring collet can’t guarantee 100% positive position. After each installation of the probe, even if the concentricity is adjusted to 10 μm, there will still be deviations when the probe is re-installed. So it is best to use a AAA /UP or higher accuracy ER spring collect (run-out tolerance