Pump&fix 45 Degrees Adjustable Handheld Shower Head Holder Suction Cup Wall Mount Bracket

Brand: PUMP&FIX

Color: off white

Features:

• ALWAYS GET STRONG SUCTION; The pressure difference by up and down movement of the button gets the air out inside of the suction cup and it makes suction stronger. As you press more times typically until you don’t see the red line, it’s always possible to get maximum suction power, 18lb.
• ADJUSTABLE SWIVEL DESIGN; It could be adjusted and stopped with tension at any angle, which is from the wall down to 45 degrees by tilting down.
• REINFORCING INDICATOR FOR LONG LASTING; The suction cup button has a red line indicator to let you know when to repump it to maintain strong suction for long-lasting.
• STANDARD FIT; The slot diameter is 24 mm, which fits almost all handheld shower head holder hose that follows an international standard. It can hold up to MAX 18 lb load on the non-porous surface such as woods, tiles, glass, mirror, PVC board, Acrylic board, antique bricks metal, etc.
• EASY INSTALLATION; It does not matter whether the surface is wet or not. Just locate it on the clean surface and pump it.

Details: (How to install and remove )
1. Clean the surface to attach and spray a little water to help increasing adhesion.
2. Pump the center button 7-8 times until the red line is not visible.
3. Tighten the knob clockwise.
4. Push card or spoon through the rubber plate and wall to remove it.

(Warm tips)
1. As you use it for a long time, a tiny refilled air in the suction cup may pop up the red line.
In this case, please press the center button again until the red line is not visible to pump air out again.
It is OK to repump when the button comes up without the red line.
2. Please clean up the suction cup with flowing water and make sure there are no other particles on the suction cup and wall when suction does not work well or reuse.
NO DRY NEEDED.
3. Please check the knob is locked; if not, tighten clockwise.

(Dimension)
Weight/EA = 3.7 ounces
Dimension = 4.8(L) X 2.8(W) X 3.0(H)
Holder top hole diameter = 24mm
Holder bottom hole diameter = 18mm

*This product does not work at the “DRYWALL.”

Package Dimensions: 84x198x132